Document Center is acquired by Nimonik

Scope

1.1 This practice covers mechanics-based requirements for calculating characteristic values for the strength and stiffness of reinforced structural glued laminated timbers (glulam) manufactured in accordance with applicable provisions of ANSI/AITC A190.1, subjected to quasi-static loadings. It addresses methods to obtain bending properties parallel to grain, about the x-x axis (Fbx and Ex) for horizontally-laminated reinforced glulam beams. Secondary properties such as bending about the y-y axis (Fby), shear parallel to grain (F vx and Fvy), tension parallel to grain (Ft), compression parallel to grain (Fc), and compression perpendicular to grain (Fc) are beyond the scope of this practice. Testing according to other applicable methods, such as Test Methods D 198, is required to establish these secondary properties. This practice also provides minimum test requirements to validate the mechanics-based model.

1.2 The practice also describes a minimum set of performance-based durability test requirements for reinforced glulams, as specified in Annex A1. Additional durability test requirements shall be considered in accordance with the specific end-use environment. Appendix X1 provides an example of a mechanics-based methodology that satisfies the requirements set forth in this standard.

1.3 Characteristic strength and elastic properties obtained using this standard may be used as a basis for developing design values. However, the proper safety, serviceability and adjustment factors including duration of load, to be used in design are outside the scope of this standard.

1.4 This practice does not cover unbonded reinforcement, prestressed reinforcement, nor shear reinforcement.

1.5 The values stated in SI units are to be regarded as standard. The mechanics based model may be developed using SI or in.-lb units.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

ICS Number Code 79.060.99 (Other wood-based panels)

To find similar documents by ASTM Volume:

04.10 (Wood)

To find similar documents by classification:

79.060.99 (Other wood-based panels)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.