ASTM-D792 › Historical Revision Information
Standard Test Methods for Density and Specific Gravity (Relative Density) of Plastics by Displacement
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These test methods describe the determination of the specific gravity (relative density) and density of solid plastics in forms such as sheets, rods, tubes, or molded items.
1.2 Two test methods are described:
1.2.1 Test Method A --For testing solid plastics in water, and
1.2.2 Test Method B--For testing solid plastics in liquids other than water.
Note 1--Alternatively, Test Method D1505 may be applied to many such forms, as well as to films and sheeting.
1.3 The values stated in SI units are to be regarded as the standard.
1.4 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 2--This standard is not equivalent to ISO 1183 Method A.
Keywords
density; relative density; specific gravity; ICS Number Code 83.120 (Reinforced plastics)
To find similar documents by ASTM Volume:
08.01 (Plastics (I): D256 - D3159)
To find similar documents by classification:
83.080.01 (Plastics in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D792-66
Revision Level
1966 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Jan. 13, 1976
Document Type
Test Method
Page Count
7 pages
Committee Number
D20.70