ASTM-D792 › Historical Revision Information
Standard Test Methods for Density and Specific Gravity (Relative Density) of Plastics by Displacement
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These test methods describe the determination of the specific gravity (relative density) and density of solid plastics in forms such as sheets, rods, tubes, or molded items.
1.2 Two test methods are described:
1.2.1 Test Method A --For testing solid plastics in water, and
1.2.2 Test Method B--For testing solid plastics in liquids other than water.
Note 1--Alternatively, Test Method D1505 may be applied to many such forms, as well as to films and sheeting.
1.3 The values stated in SI units are to be regarded as the standard.
1.4 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 2--This standard is not equivalent to ISO 1183 Method A.
Significance and Use
The specific gravity or density of a solid is a property that can be measured conveniently to identify a material, to follow physical changes in a sample, to indicate degree of uniformity among different sampling units or specimens, or to indicate the average density of a large item.
Changes in density of a single specimen may be due to changes in crystallinity, loss of plasticizer, absorption of solvent, or to other causes. Portions of a sample may differ in density because of difference in crystallinity, thermal history, porosity, and composition (types or proportions of resin, plasticizer, pigment, or filler).
Note 6—Reference is made to Test Method D 1622
Density is useful for calculating strength-weight and cost-weight ratios.
Keywords
density; relative density; specific gravity; ICS Number Code 83.120 (Reinforced plastics)
To find similar documents by ASTM Volume:
08.01 (Plastics (I): D256 - D3159)
To find similar documents by classification:
83.080.01 (Plastics in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D792-00
Revision Level
2000 EDITION
Status
Superseded
Publication Date
Dec. 10, 2000
Document Type
Test Method
Page Count
6 pages
Committee Number
D20.70