Document Center is acquired by Nimonik

Scope

1.1 This test method covers the determination of the gas content of electrical insulating oils of low and medium viscosities in the general range up to 190 cSt at 104°F (40°C), such as are used in capacitors and paper-insulated electric cables and cable systems of the oil-filled type. The determination of gas content is desirable for any insulating oil having these properties and intended for use in a degassed state.

1.2 The values stated in inch-pound units are to be regarded as the standard.

Note 1-For testing insulating oils with viscosities of 19 cSt at 40°C or below, see Test Method D2945.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

The gas content of cable and capacitor oils is considered to be important, since the evolution of gas in the form of bubbles can have an adverse effect on the insulating properties of these fluids. It is customary to degas these oils prior to use, and this test method provides a means of determining the gas content before and after degassing.

FIG. 1 Apparatus for Determination of Gas Content of Cable and Capacitor Oils

Keywords

cable oil; capacitor oil; electrical insulating oil; gas content; oil-filled cable; ICS Number Code 29.040.10 (Insulating oils)

To find similar documents by ASTM Volume:

10.03 (Electrical Insulating Liquids and Gases; Electrical Protective Equipment)

To find similar documents by classification:

29.040.10 (Insulating oils)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.