ASTM-E110 › Historical Revision Information
Standard Test Method for Indentation Hardness of Metallic Materials by Portable Hardness Testers
The following bibliographic material is provided to assist you with your purchasing decision:
This test method establishes the standard procedures, including the calibration, precision and bias of the apparatus used, for the determination of indentation hardness of metallic materials by means of portable hardness testers.
Scope
1.1 This test method covers determination of the indentation hardness of metallic materials by means of portable hardness testers.
1.2 This test method applies only to those portable hardness testers which apply the same nominal forces and use the same indenters as are used in the methods listed in Section 2.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
metallic; portable hardness tester; Hardness (indentation)--metallic materials; ICS Number Code 77.040.10 (Mechanical testing of metals)
To find similar documents by ASTM Volume:
03.01 (Metals -- Mechanical Testing; Elevated and Low-Temperature Tests; Metallography)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-E110-10
Revision Level
2010 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Feb. 15, 2010
Document Type
Test Method
Page Count
3 pages
Committee Number
E28.06