ASTM-E1226 Historical Revision Information
Standard Test Method for Explosibility of Dust Clouds

ASTM-E1226 - 1988 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Explosibility of Dust Clouds
ORDER

Scope

1.1 This test method is designed to determine the deflagration parameters of a combustible dust-air mixture within a near-spherical closed vessel of 20 L or greater volume. The parameters measured are the maximum pressure and the maximum rate of pressure rise.

1.2 Data obtained from this test method provide a relative measure of deflagration characteristics. The data have also been shown to be applicable to the design of protective measures, such as deflagration venting (1).

1.3 This test method should be used to measure and describe the properties of materials in response to heat and flame under controlled laboratory conditions and should not be used to describe or appraise the fire hazard or fire risk of materials, products, or assemblies under actual fire conditions. However, results of this test may be used as elements of a fire risk assessment that takes into account all of the factors that are pertinent to an assessment of the fire hazard of a particular end use.

Note 1-The evaluation of the deflagration parameters of maximum pressure and maximum rate of pressure rise can also be done using a 1.2-L Hartmann Apparatus. Test Method E789, has been published regarding this application; however, the use of these data in the design of deflagration venting and containment systems is not recommended.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

dust explosion; explosion pressure

To find similar documents by ASTM Volume:

14.02 (General Test Methods; Forensic Psychophysiology; Forensic Sciences; Terminology; Conformity Assessment; Statistical Methods; Nanotechnology; Forensic Engineering; Manufacture of Pharmaceutical Products)

To find similar documents by classification:

13.230 (Explosion protection Electrical apparatus for explosive atmospheres, see 29.260.20 Explosives and pyrotechnics, see 71.100.30)

17.100 (Measurement of force, weight and pressure Including measuring and weighing instruments)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-E1226-88

Revision Level

1988 EDITION

Status

Superseded

Modification Type

Revision

Publication Date

April 8, 1988

Document Type

Test Method

Page Count

11 pages

Committee Number

E27.05