ASTM-E1641 › Historical Revision Information
Standard Test Method for Decomposition Kinetics by Thermogravimetry Using the Ozawa/Flynn/Wall Method
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method describes the determination of the kinetic parameters, Arrhenius activation energy, and preexponential factor by thermogravimetry, based on the assumption that the decomposition obeys first-order kineticsusing the Ozawa/Flynn/Wall isoconversional method (1).2
1.2 This test method is generally applicable to materials with well-defined decomposition profiles, namely, a smooth, continuous mass change with a single maximum rate.
1.3 This test method is normally applicable to decomposition occurring in the range from 400 to 1300K (nominally 100 to 1000°C). The temperature range may be extended depending on the instrumentation used.
1.4 This method is similar to ISO 11358-2 but differs in its mathematical treatment.
1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
5.1 Thermogravimetry provides a rapid method for determining the temperature-decomposition profile of a material.
5.2 This test method can be used for estimating lifetimes of materials, using Test Method E1877 provided that a relationship has been established between the thermal endurance test results and actual lifetime tests.
Keywords
activation energy; pre-exponential factor; failure; failure criterion; kinetic parameters; thermal analysis; thermal decomposition; thermogravimetric analysis; ICS Number Code 71.040.40 (Chemical analysis)
To find similar documents by ASTM Volume:
14.01 (Healthcare Informatics)
To find similar documents by classification:
71.040.40 (Chemical analysis Including analysis of gases and surface chemical analysis)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-E1641-13
Revision Level
2013 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Dec. 31, 2013
Document Type
Test Method
Page Count
7 pages
Committee Number
E37.01