Document Center is acquired by Nimonik

Scope

1.1 This test method describes the procedure for the measurement of the depth of the rut at a chosen location in a pavement surface using a straightedge and a gage.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the inch-pound units are shown in parentheses. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

rut; rut-depth; straightedge; gage; ICS Number Code 93.080.20 (Road construction materials)

To find similar documents by ASTM Volume:

04.03 (Road and Paving Materials; Vehicle-Pavement Systems)

To find similar documents by classification:

93.080.20 (Road construction materials Including asphalts, road pavements, etc.)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.