ASTM-E2040 › Historical Revision Information
Standard Test Method for Mass Scale Calibration of Thermogravimetric Analyzers
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method describes the calibration or performance confirmation of the mass (or weight) scale of thermogravimetric analyzers and is applicable to commercial and custom-built apparatus.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 There is no ISO standard equivalent to this test method.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
This test method calibrates or demonstrates conformity of thermogravimetric apparatus at ambient conditions. Most thermogravimetry analysis experiments are carried out under temperature ramp conditions or at isothermal temperatures distant from ambient conditions. This test method does not address the temperature effects on mass calibration.
In most thermogravimetry experiments, the mass change is reported as weight percent in which the observed mass at any time during the course of the experiment is divided by the original mass of the test specimen. This method of reporting results assumes that the mass scale of the apparatus is linear with increasing mass. In such cases, it may be necessary only to confirm the performance of the instrument by comparison to a suitable reference.
When the actual mass of the test specimen is recorded, the use of a calibration factor to correct the calibration of the apparatus may be required, on rare occasions.
Keywords
calibration; conformity; mass; thermogravimetry; thermogravimetric analyzer; Calibration--temperature analysis instrumentation; Conformity; Mass scale calibration; Performance--laboratory instrumentation/process; Temperature calibration; Thermogravimetric analysis (TGA); ICS Number Code 71.040.50 (Physicochemical methods of analysis)
To find similar documents by ASTM Volume:
To find similar documents by classification:
19.020 (Test conditions and procedures in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-E2040-08
Revision Level
2008 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Sept. 1, 2008
Document Type
Test Method
Page Count
3 pages
Committee Number
E37.01