Document Center is acquired by Nimonik

Scope

1.1 This test method covers a procedure for measuring the strain gradient in thin, reflecting films. It applies only to films, such as found in microelectromechanical systems (MEMS) materials, which can be imaged using an optical interferometer. Measurements from cantilevers that are touching the underlying layer are not accepted.

1.2 This test method uses a non-contact optical interferometer with the capability of obtaining topographical 3-D data sets. It is performed in the laboratory.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

Strain gradient values are an aid in the design and fabrication of MEMS devices.

Keywords

cantilevers; combined standard uncertainty; fixed-fixed beams; interferometry; length measurements; microelectromechanical systems; MEMS; polysilicon; residual strain; stiction; strain gradient; test structure; ICS Number Code 37.040.20 (Photographic paper, film and plates. Cartridges)

To find similar documents by ASTM Volume:

03.01 (Metals -- Mechanical Testing; Elevated and Low-Temperature Tests; Metallography)

To find similar documents by classification:

37.040.20 (Photographic paper, films and plates. Cartridges)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.