ASTM-E695 › Historical Revision Information
Standard Method for Measuring Relative Resistance of Wall, Floor, and Roof Construction to Impact Loading
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This method covers the measurement of the relative resistance of wall, floor, and roof construction to impact loading. The test is not applicable to doors.
1.2 The values stated in SI units are to be regarded as the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
The procedures outlined will provide data that can be used to evaluate the relative performance of wall, floor, and roof constructions under conditions representative of those sustained in actual service when subjected to impact by a heavy blunt object. See Test Method E 661
The method is intended to be applied to relatively light construction, including, but not limited to, wood floor and roof systems, partitions framed with wood or steel studs, steel floor or roof decking systems, steel siding and wall panels, or thin concrete and masonry walls or slabs and similar assemblies.
Keywords
floor systems; impact loading; roof systems; wall systems; ICS Number Code 91.060.01 (Elements of buildings in general)
To find similar documents by ASTM Volume:
04.11 (Building Constructions (I): E72 - E2110)
To find similar documents by classification:
91.060.01 (Elements of buildings in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-E695-03
Revision Level
2003 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Oct. 1, 2003
Document Type
Test Method
Page Count
5 pages
Committee Number
E06.11