ASTM-E955 › Historical Revision Information
Standard Test Method for Thermal Characteristics of Refuse-Derived Fuel Macrosamples
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of moisture, noncombustibles and combustibles, and the calculation of higher heating value content of a large mass of refuse-derived fuel-three (RDF).
1.2 This test method may be applicable to any waste material, including residues from combustion, from which a representative sample can be prepared.
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See Section 7 for additional hazard information.
Keywords
Combustible matter content; Heating tests-refuse-derived fuel/waste; Moisture analysis-refuse-derived fuel/RDF; Noncombustible matter content; Resource recovery-solid waste refuse-derived fuel/RDF; thermal characteristics of refuse-derived fuel/RDF, test,; Thermal transmission properties; refuse-derived fuel-3 (RDF-3), test; ICS Number Code 75.160.10 (Solid fuels)
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-E955-88
Revision Level
1988 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
March 25, 1988
Document Type
Test Method
Page Count
3 pages
Committee Number
D34.03