ASTM-E963 › Historical Revision Information
Electrolytic Extraction of Phases From NI & NI-Fe Base Superalloys Using a Hydrochloric-Me
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice covers a procedure for the isolation of carbides, borides, TCP (topologically close-packed), and GCP (geometrically close-packed) phases (Note 1) in nickel and nickel-iron base gamma prime strengthened alloys. Contamination of the extracted residue by coarse matrix (gamma) or gamma prime particles, or both, reflects the condition of the alloy rather than the techniques mentioned in this procedure.
1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
This practice can be used to extract carbides, borides, TCP and GCP phases, which can then be qualitatively or quantitatively analyzed by X-ray diffraction or microanalysis.
Careful control of parameters is necessary for reproducible quantitative results. Within a given laboratory, such results can be obtained routinely; however, caution must be exercised when comparing quantitative results from different laboratories.
Comparable qualitative results can be obtained routinely among different laboratories using this procedure.
Keywords
borides; carbides; electrolytic extraction; Gamma prime; GCP phases; superalloys; TCP phases; Borides; Carbides; Electrolytic extraction; GCP phases (of multiphasic materials); Nickel alloys; Nickel-iron alloy; Superalloy steel; TCP phases (of multiphasic materials); Ultrasonic testing; ICS Number Code 77.120.40 (Nickel, chromium and their alloys)
To find similar documents by ASTM Volume:
03.01 (Metals -- Mechanical Testing; Elevated and Low-Temperature Tests; Metallography)
To find similar documents by classification:
77.120.40 (Nickel, chromium and their alloys)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-E963-95(2010)
Revision Level
1995 R10 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
May 1, 2010
Document Type
Practice
Page Count
4 pages
Committee Number
E04.11