ASTM-F1141 › Historical Revision Information
Standard Specification for Wallcovering
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers the performance, quality, packaging, and marking requirements for flexible wall coverings as a finished product. Also included here are wall preparation and covering installation procedures. The manufacturers shall be responsible for thorough testing and inspection under representative field conditions prior to introduction of new finished products on the market.
Scope
1.1 This specification covers the performance, quality, packaging, and marking characteristics of flexible wall covering as a finished product.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
Keywords
backing (substrate); bias; bolt; facing; finished product; intermediate layer; lot (batch); pattern match; pattern repeat; protective layer; register; run; seconds; selvage; shading and waste edge; split bolt; wallcovering; Backing fabrics/materials; Bias (fabric); Facing; Wallcovering materials/applications; ICS Number Code 91.180 (Interior finishing)
To find similar documents by ASTM Volume:
To find similar documents by classification:
91.180 (Interior finishing Paint coating processes, see 87.020)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F1141-93(2009)
Revision Level
1993 R09 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
April 1, 2009
Document Type
Specification
Page Count
3 pages
Committee Number
F15.15