ASTM-F1141 › Historical Revision Information
Standard Specification for Wall Coverings
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers the performance, quality, packaging, and marking requirements for flexible wall coverings as a finished product. Also included here are wall preparation and covering installation procedures. The manufacturers shall be responsible for thorough testing and inspection under representative field conditions prior to introduction of new finished products on the market.
Scope
1.1 This specification covers the performance, quality, packaging, and marking characteristics of flexible wall coverings as finished products.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems has the potential to result in non-conformance with the standard.
Keywords
backing (substrate); bias; bolt; facing; finished product; intermediate layer; lot (batch); pattern match; pattern repeat; protective layer; register; run; seconds; selvage; shading and waste edge; split bolt; wall covering ;
To find similar documents by ASTM Volume:
To find similar documents by classification:
91.180 (Interior finishing Paint coating processes, see 87.020)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F1141/F1141M-15
Revision Level
2015 EDITION
Status
Superseded
Modification Type
Revision with Designation Change
Publication Date
Jan. 15, 2016
Document Type
Specification
Page Count
3 pages
Committee Number
F15.15