ASTM-F1175 › Historical Revision Information
Standard Practice for Using the Computer Impact Print-Out Unit as a Test Instrument for Manifold Comparison
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice covers a standardized procedure utilizing the computer impact print-out unit as an imaging device where the performance properties of carbonless paper, carbon paper, and similar image-producing products are measured. The printer can be either a high speed printer connected to a mainframe computer or a printer connected to a personal or mini-computer.
1.2 The values stated in inch-pound units are to be regarded as the standard. The SI values in parentheses are given for information only.
1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
carbonless paper; carbon paper; computer impact print-out; continuous printing; imaging device; impact printer; manifold set
To find similar documents by ASTM Volume:
15.09 (Paper; Business Imaging Products)
To find similar documents by classification:
35.180 (IT terminal and other peripheral equipment Including modems)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F1175-88(1996)e1
Revision Level
1988 R96(E1) EDITION
Status
Superseded
Modification Type
Reapproval with Ed Change
Publication Date
Dec. 1, 1996
Document Type
Practice
Page Count
4 pages
Committee Number
F05.06