ASTM-F1176 › Historical Revision Information
Design & Installation of Underground Thermoplastic Irrigation Systems With Maximum Working
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice establishes procedures for the design and installation of thermoplastic flexible piping systems, for underground irrigation systems. Because there is considerable variability in end-use requirements, soil conditions, and thermoplastic piping characteristics, the intent of this practice is to outline general objectives and basics of systems design, proper installation procedures, and to provide pertinent references.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are mathematical conversions to SI units which are for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
underground thermoplastic; irrigation systems; ICS Number Code 65.060.35 (Irrigation and drainage equipment)
To find similar documents by ASTM Volume:
08.04 (Plastic Piping Systems)
To find similar documents by classification:
65.060.35 (Irrigation and drainage equipment)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F1176-01
Revision Level
2001 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Aug. 10, 2001
Document Type
Practice
Page Count
7 pages
Committee Number
F17.61