ASTM-F1216 › Historical Revision Information
Standard Practice for Rehabilitation of Existing Pipelines and Conduits by the Inversion and Curing of a Resin-Impregnated Tube
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice describes the procedures for the reconstruction of pipelines and conduits (4 to 108-in. diameter) by the installation of a resin-impregnated, flexible tube which is inverted into the existing conduit by use of a hydrostatic head or air pressure. The resin is cured by circulating hot water or introducing controlled steam within the tube. When cured, the finished pipe will be continuous and tight-fitting. This reconstruction process can be used in a variety of gravity and pressure applications such as sanitary sewers, storm sewers, process piping, electrical conduits, and ventilation systems.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements, see 7.4.2.
Significance and Use
This practice is for use by designers and specifiers, regulatory agencies, owners, and inspection organizations who are involved in the rehabilitation of conduits through the use of a resin-impregnated tube inverted through the existing conduit. As for any practice, modifications may be required for specific job conditions.
Keywords
Resin-impregnated tube; Resins; Sewer pipe (thermoplastic); Thermosetting plastic pipe/tubing/fittings; Steel pipe; Styrene; Underground installation--water supply/distribution systems; Water supply/distribution systems; Bypassing; Conduit joining system; Conduits; Curing (in pipeline/conduit rehabilitation); Drainage materials/systems; Drain/waste/vent (DWV)--thermoplastics; Epoxy resin pipe fittings; Epoxy resins; Gravity sewer pipe; Inspection; Inversion; Land drainage piping systems; Nonpressure piping; Polybutylene (PB) pipe; Polyethylene (PE) conduit; Polyethylene (PE) pipe; Poly(vinyl chloride)(PVC) conduits; Pressure pipelines/piping systems; Rehabilitation--sewerlines; Reinforced thermosetting-resin pipe (RTRP); ICS Number Code 23.040.20 (Plastic pipes)
To find similar documents by ASTM Volume:
08.04 (Plastic Piping Systems)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F1216-09
Revision Level
2009 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
March 1, 2009
Document Type
Practice
Page Count
8 pages
Committee Number
F17.67