ASTM-F1236 › Historical Revision Information
Standard Guide for Visual Inspection of Electrical Protective Rubber Products
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 The purpose of this guide is to present methods and techniques for the visual inspection of electrical protective rubber products. This guide also includes descriptions and photographs of irregularities found in these products.
Note—It is not the purpose of this guide to establish the acceptance level of any irregularity described herein. That shall be established by the standard for each product.
1.2 The values stated in inch-pound units are to be regarded as standard. The SI units in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
electrical protective equipment-rubber; inflation inspection procedure; inspection; lighting inspection procedure; rolling inspection procedure; visual examination-electrical insulating materials; visual inspection of electrical protective rubber products guide; ICS Number Code 29.035.20 (Plastic and rubber insulating materials)
To find similar documents by ASTM Volume:
10.03 (Electrical Insulating Liquids and Gases; Electrical Protective Equipment)
To find similar documents by classification:
29.035.20 (Plastics and rubber insulating materials Including adhesive tapes)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F1236-96
Revision Level
1996 EDITION
Status
Superseded
Publication Date
March 10, 1996
Document Type
Guide
Page Count
11 pages
Committee Number
F18.60