ASTM-F1290 › Historical Revision Information
Electrofusion Joining Polyolefin Pipe & Fittings, Standard Practice For
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice describes general procedures for making joints with polyolefin pipe and fittings by means of electrofusion joining techniques. These should be regarded as general procedures and not as a substitute for the installation procedures specified by the manufacturers. Manufacturers should be requested to supply specific recommendations for joining their products. Note 1Reference to the manufacturer in this practice is defined as the electrofusion fitting manufacturer.
1.2 The techniques covered are applicable only to joining polyolefin pipe and fittings of related polymer chemistry, for example, polyethylenes to polyethylenes using a polyethylene electrofusion fitting. Consult the manufacturer's recommendations for compatibility of the electrofusion fitting with the specific pipe or fitting material to be joined.
1.3 The electrofusion joining technique described can produce sound joints between polyolefin pipe and fittings, provided that all products involved (that is, pipe and fittings) meet the appropriate ASTM specifications.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
Using the procedures in Sections 8 and 9, the manufacturer’instructions and equipment, pressure-tight joints can be made between manufacturer-recommended combinations of pipe that are as strong as the pipe itself.
Keywords
ICS Number Code 23.040.20 (Plastic pipes); 23.040.45 (Plastic fittings)
To find similar documents by ASTM Volume:
08.04 (Plastic Piping Systems)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F1290-98
Revision Level
1998 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
May 10, 1998
Document Type
Practice
Page Count
3 pages
Committee Number
F17.20