ASTM-F1380 › Historical Revision Information
Metal Insert Fittings for Polybutylene (Pb) Tubing, Standardspecification For
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers metal insert fittings for polybutylene (PB) plastic tubing. These fittings are intended for use in 100 psi (6.9 MPa) cold- and hot-water distribution systems operating at temperatures up to and including 180°F (82°C). Included are the requirements for materials, workmanship, burst pressure, sustained pressure, temperature cycling tests, and markings to be used on the fittings.
1.2 The values stated in inch-pound units are to be regarded as the standard. The SI values stated in parentheses are provided for information purposes.
1.3 The following precautionary caveat pertains only to the test method portion, Section 9, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
Cold water supply/distribution systems; Crimp rings; Hot water supply/distribution systems; Metal insert fittings; Pipe fittings-PB (polybutylene); Polybutylene (PB) tube; Water supply/distribution systems; metal insert fittings-polybutylene (PB) tubing (for cold-/hot-water; distribution systems), spec.,; Copper crimp rings; metal insert fittings-polybutylene (PB) tubing (forcold-/hot-water; distribution systems)
To find similar documents by ASTM Volume:
08.04 (Plastic Piping Systems)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F1380-94
Revision Level
1994 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Feb. 15, 1994
Document Type
Specification
Page Count
5 pages
Committee Number
F17.61