Document Center is acquired by Nimonik

Scope

1.1 These test methods describe laboratory equipment, procedures, and basic requirements pertinent to testing protective headgear. Deviations or additions, or both, to these test methods will be specified, as required, in individual performance standard specifications.

1.2 Requirements—The protective headgear is to be tested under specified environmental conditions for the following:

1.2.1 Impact attenuation (the limiting of head acceleration) of the protective headgear.

1.2.2 Strength of the retention system and its attachment.

1.2.3 Special tests for particular protective headgear uses will be specified in the individual standard specifications to be used in conjunction with these test methods.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

helmet; individual standard specfication; protective headgear

To find similar documents by ASTM Volume:

15.07 (Sports Equipment and Facilities; Pedestrian/Walkway Safety and Footwear; Amusement Rides and Devices; Snow Skiing)

To find similar documents by classification:

13.340.20 (Head protective equipment Including helmets, eye-protectors, hearing protectors, ear muffs, teeth protectors and hoods.)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.