ASTM-F1813 › Historical Revision Information
Standard Specification for Wrought Titanium - 12 Molybdenum - 6 Zirconium - 2 Iron Alloy for Surgical Implant (UNS R58120)
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers the chemical, mechanical, and metallurgical requirements for wrought titanium-12 molybdenum- 6 zirconium-2 iron alloy for surgical implants to be used in the manufacture of surgical implants. The heat analysis shall conform to the chemical composition requirements prescribed. Ingot analysis may be used for reporting all chemical requirements, except hydrogen. The wrought titanium-12 molybdenum-6 zirconium-2 iron alloy are classified as bar, forging bar and wire. The ultimate tensile strength, yield strength, elongation, and area reduction of the material shall be tested to meet the requirements prescribed.
Scope
1.1 This specification covers the chemical, mechanical, and metallurgical requirements for wrought titanium–12 molybdenum–6 zirconium–2 iron alloy for surgical implants to be used in the manufacture of surgical implants.
1.2 The values stated in inch pound units are to be regarded as the standard. The SI equivalents in parentheses are for information only.
Keywords
metals (for surgical implants); orthopaedic medical devices; titanium alloys; titanium alloys (for surgical implants); ICS Number Code 11.040.30 (Surgical instruments and materials)
To find similar documents by ASTM Volume:
13.01 (Medical and Surgical Materials and Devices)
To find similar documents by classification:
11.040.30 (Surgical instruments and materials Including surgical dressings, sutures, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F1813-06
Revision Level
2006 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Dec. 1, 2006
Document Type
Specification
Page Count
4 pages
Committee Number
F04.12