ASTM-F1865 › Historical Revision Information
Mechanical Cold Expansion Insert Fitting With Compression Sleeve for Cross-Linked Polyethy
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers mechanical cold expansion insert fittings with compression sleeve suitable for use with cross-linked polyethulene PEX plastic tubing in 3/8, 1/2, 5/8, 3/4, 1in. and larger nominal diameters that meet the requirements of Specifications F 876 and F 877. These fittings are intended for use in 100 psi (689.5 kPa) cold and hot water distributions systems operating at temperatures up to and including 180° F (82°C). Included are the requirements for materials, workmanship, dimensions, and markings to be used on the fittings and compression sleeves
1.2 The values stated in inch-pounds units are to be regarded as the standard. The values given in parentheses are mathematical conversions to SI units which are provided for provided for information only and are not considered the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
cold and hot water distribution; cold expansion insert fittings; compression sleeve; crosslinked polyethylene; PEX; ICS Number Code 23.040.45 (Plastic fittings)
To find similar documents by ASTM Volume:
08.04 (Plastic Piping Systems)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F1865-02e1
Revision Level
2002(E1) EDITION
Status
Superseded
Modification Type
Editorially changed
Publication Date
Dec. 20, 2002
Document Type
Specification
Page Count
4 pages
Committee Number
F17.10