ASTM-F1865 › Historical Revision Information
Standard Specification for Mechanical Cold Expansion Insert Fitting With Compression Sleeve for Cross-linked Polyethylene (PEX) Tubing (Withdrawn 2018)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers mechanical cold expansion insert fittings with compression sleeve suitable for use with PEX tubing that meets the requirements of Specification F 876 or F 877. These fittings are intended for use in 100 psi (689.5 kPa) cold and hot water distributions systems operating at temperatures up to and including 180°F (82°C). Included are the requirements for material, workmanship, dimensions, burst pressure, sustained pressure, excessive temperature and pressure, temperature cycling tests, and markings to be used on the fittings and compression sleeves.
1.2 The values stated in inch-pounds units are to be regarded as the standard. The values given in parentheses are provided for information purposes only.
1.3 The precautionary caveat pertains only to the test method portion, Section 10, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
cold and hot water distribution; cold expansion insert fittings; compression sleeve; crosslinked polyethylene; PEX; ICS Number Code 23.040.45 (Plastic fittings)
To find similar documents by ASTM Volume:
08.04 (Plastic Piping Systems)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F1865
Revision Level
WITHDRAWN
Status
Cancelled
Modification Type
New
Publication Date
Jan. 1, 2018
Document Type
Specification
Page Count
5 pages
Committee Number
F17.26