Document Center is acquired by Nimonik

Scope

1.1 This specification covers virgin poly(L-lactic acid) resin (or abbreviated as PLLA resin) intended for use in surgical implants. This specification does not cover stereoisomeric composition based on various D, L, DL copolymer ratios.

1.2 This specification addresses material characteristics of virgin poly(L-lactic acid) resin and does not apply to packaged and sterilized finished implants fabricated from this material.

1.3 As with any material, some characteristics may be altered by processing techniques (such as molding, extrusion, machining, assembly, sterilization, etc.) required for the production of a specific part or device. Therefore, properties of fabricated forms of this resin should be evaluated using those test methods which are appropriate to assure safety and efficacy.

1.4 The values stated in SI units are to be regarded as the standard.

1.5 The following precautionary statement pertains only to the test method portion, Section 6, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

PLLA; poly(L-lactic acid); polylactide; virgin polymer; ICS Number Code 11.040.40 (Implants for surgery, prothetics and orthotics); 83.080.20 (Thermoplastic materials)

To find similar documents by ASTM Volume:

13.01 (Medical and Surgical Materials and Devices)

To find similar documents by classification:

11.040.40 (Implants for surgery, prosthetics and orthotics Including pacemakers Ophthalmic implants, see 11.040.70)

83.080.20 (Thermoplastic materials)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.