ASTM-F2066 › Historical Revision Information
Standard Specification for Wrought Titanium-15 Molybdenum Alloy for Surgical Implant Applications (UNS R58150)
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers the chemical, mechanical, and metallurgical requirements for wrought titanium-15 molybdenum alloy to be used in the manufacture of surgical implants. The product shall be classified as: strip; sheet; plate; bar; or wire. The heat analysis shall conform to the chemical composition prescribed. Material shall be furnished in the beta annealed condition. Bend tests and tension tests shall be performed to conform to the specified requirements.
Scope
1.1 This specification covers the chemical, mechanical, and metallurgical requirements for wrought titanium-15 molybdenum alloy to be used in the manufacture of surgical implants
1.2 The values stated in inch-pound units are to be regarded as the standard. The SI equivalents in parentheses are for information only.
Keywords
metals (for surgical implants); orthopaedic medical devices; titanium alloys; titanium alloys (for surgical implants); ICS Number Code 11.040.30 (Surgical instruments and materials)
To find similar documents by ASTM Volume:
13.01 (Medical and Surgical Materials and Devices)
To find similar documents by classification:
11.040.30 (Surgical instruments and materials Including surgical dressings, sutures, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F2066-07
Revision Level
2007 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
April 1, 2007
Document Type
Specification
Page Count
5 pages
Committee Number
F04.12