Document Center is acquired by Nimonik

Scope

1.1 This specification covers material, dimensional, workmanship and performance requirements for polyethylene conduit, duct and innerduct manufactured for use in a non- pressure application with communication, CATV, or power wire and cables.

1.2 HDPE conduit meeting the requirements of this standard shall be made as OD controlled solid wall, with or without internal or external ribs. The sizing shall be Iron Pipe Size (IPS) with noted exceptions in tables. The internal or external surface may contain a coextruded layer provided the finished conduit meets the product requirements of this specification.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 The following precautionary caveat pertains only to the test method portion, Section 6, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.

Keywords

conduit; polyethylene; true size; True size; Conduits--specifications; Ducts/duct liners; High-density polyethylene (HDPE); Nonpressure piping--specifications; Polyethylene (PE)--specifications; Polyethylene (PE) conduit; ICS Number Code 29.120.10 (Conduits for electrical purposes)

To find similar documents by ASTM Volume:

08.04 (Plastic Piping Systems)

To find similar documents by classification:

29.120.10 (Conduits for electrical purposes)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.