ASTM-F2497 › Historical Revision Information
Standard Practice for Abrasion and Scuff Resistance of Inkjet Media by the Sutherland Rub Tester
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice covers a procedure for determining the abrasion resistance of printed and unprinted inkjet media using the Sutherland Rub Tester, or its equivalent, equipped with full-width rubber pads and using standardized receptors.
1.2 This practice is applicable to printed and unprinted inkjet media.
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
abrasion; gloss; ink; Inkjet media; printing; rub; scuffing; Sutherland; ICS Number Code 37.100.10 (Reproduction equipment)
To find similar documents by ASTM Volume:
15.09 (Paper; Business Imaging Products)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F2497-05
Revision Level
2005 EDITION
Status
Superseded
Modification Type
New
Publication Date
June 1, 2005
Document Type
Practice
Page Count
3 pages
Committee Number
F05.07