ASTM-F2907 › Standard Consumer Safety Specification for Sling Carriers
Show Complete Document History
The following bibliographic material is provided to assist you with your purchasing decision:
This consumer safety specification establishes performance requirements, test methods and marking requirements to promote safe use of sling carriers. It indicates the performance requirements and test methods of sling carriers; these tests are the static load test, dynamic load test, adhesion test, occupant retention test, and restraint system. This specification also identifies the proper markings and labels that should be placed on the sling carriers.
1.1 This consumer safety specification establishes performance requirements, test methods and marking requirements to promote safe use of sling carriers.
1.2 This consumer safety specification is intended to minimize the risk of injury to an occupant from the normal use and reasonably foreseeable misuse of products.
1.3 For purposes of definition, a sling carrier is a product of fabric or sewn fabric construction, which is designed to contain up to two (2) children in an upright or reclined position while being supported by the caregiver’s torso. Sling carriers are normally used from full-term birth to 35 lb (15.9 kg) unless the manufacturer indicates that a higher weight limit is allowed.
Note 1: Slings consist of a variety of unstructured designs ranging from a hammock-shaped product suspended on the caregiver’s upper torso to a long length of material wrapped around the caregiver’s body.
1.4 The sling carrier is normally “worn” by the caregiver, and thus the child is supported from one or both shoulders of the caregiver. These products are worn on the front, hip or back of the caregiver, with the child either facing towards or away from the caregiver or reclined on the front only of the caregiver.
1.5 No sling carrier produced after the approval date of this consumer safety specification shall, either by label or other means, indicate compliance with the specification unless it complies with all of the requirements contained herein.
1.6 This consumer safety specification is not intended to address incidents and injuries resulting from the interaction of other persons or objects with the caregiver and child while the sling carrier is in use.
1.7 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.8 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.9 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Nov. 26, 2019