ASTM-F2933 › Historical Revision Information
Standard Consumer Safety Specification for Crib Mattresses
The following bibliographic material is provided to assist you with your purchasing decision:
This consumer safety specification establishes design requirements, testing requirements and methods, and requirements for labeling for full-size and non-full-size crib mattresses. Crib mattress produced after the approval date of this specification shall be deemed non-compliant unless it conforms to all requirements described by the specification. The standard covers calibration and standardization, test methods, and marking and labeling.
Scope
1.1 This consumer safety specification establishes design requirements, testing requirements and methods, and requirements for labeling for full-size crib mattresses, non-full-size crib mattresses, and after-market mattresses for play yards and non-full size cribs.
1.2 No crib mattress produced after the approval date of this consumer safety specification shall, either by label or other means, indicate compliance with this specification unless it conforms to all requirements contained herein.
1.3 Units—The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Keywords
crib mattress; safety requirements;
To find similar documents by ASTM Volume:
To find similar documents by classification:
97.140 (Furniture Including upholstery, mattresses, office furniture, school furniture, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F2933-18
Revision Level
2018 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Aug. 15, 2018
Document Type
Specification
Page Count
6 pages
Committee Number
F15.66