Document Center is acquired by Nimonik

Scope

1.1 This practice covers a procedure that is used to determine the fusion temperature of dry electrostatic heat-fixing toners using a micro hot stage.

1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of whoever uses this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See Section 6 for specific precautionary statements.

Keywords

fusion point; melt point; toners; ICS Number Code 37.100.20 (Materials for graphic technology)

To find similar documents by ASTM Volume:

15.09 (Paper; Business Imaging Products)

15.11 (Consumer Products; Light Sport Aircraft; Unmanned Aircraft Systems; Normal and Utility Category Airplane Electrical Wiring Systems; Unmanned Maritime Vehicle Systems (UMVS))

To find similar documents by classification:

37.100.20 (Materials for graphic technology Inks, see 87.080)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.