ASTM-F725 › Historical Revision Information
Standard Practice for Drafting Impact Test Requirements In Thermoplastic Pipe And Fittings Standards
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice describes a procedure for setting up impact test requirements on the basis of test data obtained by Test Method D2444.
1.2 This practice is applicable to thermoplastic pipe and fittings.
1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
Impact testing-plastics; Pipe fittings-plastic (general); Plastic pipe/tubing/fittings-thermoplastic; drafting impact test requirements in thermoplastic pipe/fitting; standards, practice,; Resistance-impact (plastics); thermoplastic pipe/fittings-drafting impact test requirements in; standards, practice; ICS Number Code 23.040.20 (Plastic pipes); 23.040.45 (Plastic fittings)
To find similar documents by ASTM Volume:
08.04 (Plastic Piping Systems)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F725-89(1996)
Revision Level
1989 R96 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
Dec. 29, 1989
Document Type
Practice
Page Count
4 pages
Committee Number
F17.40