ASTM-F725 › Historical Revision Information
Standard Practice for Drafting Impact Test Requirements In Thermoplastic Pipe And Fittings Standards
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice describes a procedure for setting up impact test requirements on the basis of test data obtained by Test Method D 2444
1.2 This practice is applicable to thermoplastic pipe and fittings.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
This practice is used for drafting impact test specification requirements, and it presupposes no special familiarity with statistical methods. It provides for specification values that will pass acceptable lots with a high degree of certainty. The impact test requirement is intended to discriminate between acceptable materials and manufacturing methods and those which are not; it is not a simulated service test.
Keywords
drafting impact; drafting impact requirements; impact; plastic pipe; plastic tubing; thermoplastic pipe; thermoplastic tubing; Drafting impact test requirements; Impact resistance--plastics; Impact testing--plastics; Thermoplastic pipe/tube/fittings; ICS Number Code 23.040.20 (Plastic pipes); 23.040.45 (Plastic fittings)
To find similar documents by ASTM Volume:
08.04 (Plastic Piping Systems)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F725-03(2008)e1
Revision Level
2003 R08(E1) EDITION
Status
Superseded
Modification Type
Reapproval with Ed Change
Publication Date
March 1, 2008
Document Type
Practice
Page Count
4 pages
Committee Number
F17.40