ASTM-F771 › Historical Revision Information
Standard Specification for Polyethylene (PE) Thermoplastic High-Pressure Irrigation Pipeline Systems (Withdrawn 2014)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers polyethylene (PE) thermoplastic pipelines used to convey, at rated pressures of 80 to 200 psi, water that is to be used for irrigation purposes. This specification includes criteria for classifying the pipe materials, a system of nomenclature for plastic pipe, requirements for pipe, test methods, joints, fittings, certification, and marking.
1.2 The values stated in inch-pound units are to be regarded as the standard.
1.3 The following safety hazards caveat pertains only to the test method portion, Section 7, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
Irrigation piping; Land drainage piping systems; polyethylene (PE) thermoplastic high-pressure irrigation pipeline; systems-classifying materials/identifying requirements, spec.,; Polyethylene (PE) pipe; high-pressure irrigation pipeline systems-classifying; materials/identifying requirements, spec.,;
To find similar documents by ASTM Volume:
08.04 (Plastic Piping Systems)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F771-95
Revision Level
1995 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Sept. 10, 1995
Document Type
Specification
Page Count
8 pages
Committee Number
F17.61