ASTM-F803 › Historical Revision Information
Standard Specification for Eye Protectors For Selected Sports
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers eye protectors, designed for use by players of racket sports, women's lacrosse, field hockey, basketball, baseball, and soccer that minimize or significantly reduce injury to the eye and adnexa due to impact and penetration by racket-sport rackets and balls, women's lacrosse and field hockey sticks and balls, baseballs, soccer balls, hands, elbows, and fingers. Protective eyewear offers protection only to the eyes and does not protect other parts of the head. Protectors are divided into four types depending on their design characteristics as follows: Type I—A protector with the lens or lenses and frame frontpiece molded as one unit. Frame temples or other devices, such as straps, to affix the lens/frontpiece may be separate pieces; Type II—A protector with a single lens or lenses, either plano or prescription, mounted in a frame that was manufactured as a separate unit; Type III—A protector without a lens; and Type IV—A full or partial face shield. Materials shall be tested using optical tests such as field of view, optical quality, luminous transmittance, prismatic deviation measurements, haze, refractive power measurements, surface imperfections and internal defects, and alternate optical tests; and mechanical tests such as high velocity impact resistance, and projectile simulator test. In addition, the individual grades shall conform to the general, and performance requirements.
Scope
1.1 This specification covers eye protectors, designed for use by players of racket sports, women's lacrosse, field hockey, basketball, and baseball that minimize or significantly reduce injury to the eye and adnexa due to impact and penetration by racket-sport rackets and balls, women's lacrosse and field hockey sticks and balls, baseballs, and hands, elbows, and fingers. Protective eyewear offers protection only to the eyes and does not protect other parts of the head.
1.2 Protectors are divided into four types depending on their design characteristics.
1.3 This specification applies to eye protectors for use by wearers of corrective lenses and also by those players who do not require prescription eyewear.
Note 1—Warning Polycarbonate spectacle lenses should be used if spectacles are worn under protective eyewear.
1.4 In this standard, the use of the words "shall" or "must" indicates a mandatory requirement. The word "should" indicates a recommendation.
1.5 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. Metric units of measurement in this specification are in accordance with the International System of Units (SI). If a value for measurement as given in this specification is followed by an equivalent value in other units, the first stated is to be regarded as the requirement. A given equivalent value may be approximate.
1.6 The following precautionary caveat pertains only to the test methods portions, Sections 9-11, of this specification:This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
consumer safety specifications-sports equipment; eye protectors; ICS Number Code 13.340.20 (Head protective equipment); 97.220.40 (Outdoor and water sports equipment)
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F803-03
Revision Level
2003 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Aug. 10, 2003
Document Type
Specification
Page Count
14 pages
Committee Number
F08.57