ASTM-F810 › Historical Revision Information
Standard Specification for Smoothwall Polyethylene (PE) Pipe for Use in Drainage and Waste Disposal Absorption Fields
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers smoothwall perforated and nonperforated polyethylene (PE) pipe for use in drainage and waste disposal absorption fields. It covers requirements and test methods for workmanship, flattening, dimensions, tolerances, stiffness, perforations, environmental stress cracking, bonding, and impact resistance. Materials for pipe shall be PE compounds which may consist of lubricants, stabilizers, nonpoly(ethylene) resin modifiers, and pigments. Marking, labeling, installation, and quality assurance shall conform to the requirements of this specification.
Scope
1.1 This specification covers requirements and test methods for workmanship, flattening, dimensions, tolerances, stiffness, perforations, environmental stress cracking, bonding, and impact resistance for smoothwall perforated and nonperforated polyethylene (PE) pipe, including coextruded and closed profile pipe. Methods of marking are also included.
1.2 This specification includes two stiffness classes, referred to as, “Standard” and “Heavy Duty.”
1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 The text of this specification references notes and footnotes that provide explanatory material. These notes and footnotes, excluding those in tables and figures, shall not be considered as requirements of this specification.
1.5 The following precautionary caveat pertains only to the test method portion, Section 7, of this specification: This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of whoever uses this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
drain pipe; fittings; perforated pipe; pipe; polyethylene; under-drain; ICS Number Code 23.040.20 (Plastic pipes)
To find similar documents by ASTM Volume:
08.04 (Plastic Piping Systems)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F810-12
Revision Level
2012 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Feb. 1, 2013
Document Type
Specification
Page Count
4 pages
Committee Number
F17.65