ASTM-F894 › Historical Revision Information
Standard Specification for Polyethylene (PE) Large Diameter Profile Wall Sewer and Drain Pipe
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers requirements and test methods for materials, dimensions, workmanship, ring stiffness, flattening, joint systems, and a form of marking for large diameter, 10 to 120 in. (250 to 3050 mm), inside diameter based polyethylene (PE) pipe of profile wall construction and with butt-fused, bell and spigot, and other mechanical joints for use in low pressure and gravity flow applications, such as for sewers and drains. Note 1Pipe produced to this specification should be installed in accordance with Practice D 2321 and with the manufacturer's recommendations.
Note 2
For purposes of this specification, low pressure is defined as 50 ft (15.2 m) of water column or less.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values in parentheses are provided for information only.
Keywords
ICS Number Code 23.040.20 (Plastic pipes)
To find similar documents by ASTM Volume:
08.04 (Plastic Piping Systems)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F894-06
Revision Level
2006 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Aug. 15, 2006
Document Type
Specification
Page Count
10 pages
Committee Number
F17.26