ASTM-F957 › Historical Revision Information
Standard Specification for Gong, Sound Signaling
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers gongs for use on ships of certain length, as required by International Regulations. The gong cylinder, brackets, clapper rod, "U" bracket, washers, and clapper support pin shall be made of stainless steel. The clapper mass shall be made of cast alloy steel. In addition, the support bolt, nut, flat washer, and cotter pins shall be made of stainless steel compatible with the other materials. The general arrangement of the assembled gong, as well as details of the gong cylinder, brackets, clapper, and miscellaneous fittings are presented. The sound characteristics of these gongs shall be determined by an acoustic test. These gongs shall be free from cracks, burrs, sharp cutting edges, and other defects affecting their life, appearance, and serviceability.
Scope
1.1 This specification covers gongs for use on ships 100 m or more in length, as required by International Regulations (see Appendix X1).
1.2 For consistency with International Regulations, all measurements are in SI units.
Keywords
clapper; gong; gong cylinder; signaling; sound signaling ; Bells; Gongs; Shipbuilding materials (general)--specifications; ICS Number Code 47.020.70 (Navigation and control equipment)
To find similar documents by ASTM Volume:
01.07 (Ships and Marine Technology)
To find similar documents by classification:
47.020.70 (Navigation and control equipment Radiocommunications equipment, see 33.060)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-F957-91(2012)
Revision Level
1991 R12 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
May 31, 2012
Document Type
Specification
Page Count
5 pages
Committee Number
F25.07