Document Center is acquired by Nimonik

Scope

1.1 This specification covers plastic guard equipment and guard systems used by workers for temporary insulation on electric power circuits.

1.2 Plastic guard equipment covered by this specification is rated for momentary, or brush contact only. Maximum-use voltages are covered in Annex A1.

1.3 Typical guards covered include, but are not limited to, the following:

1.3.1 Conductor guards and connecting covers as follows:

1.3.1.1 Line guards,

1.3.1.2 Line guard connectors,

1.3.1.3 Insulator covers,

1.3.1.4 Dead end covers,

1.3.1.5 Bus guards, and

1.3.1.6 Bus "T" guards.

1.3.2 Structure and apparatus covers as follows:

1.3.2.1 Pole guards,

1.3.2.2 Ridge pin covers,

1.3.2.3 Switch-blade covers,

1.3.2.4 Arm guards,

1.3.2.5 Cutout covers, and

1.3.2.6 Cross arm guard.

1.4 The values stated in inch-pound units are to be regarded as the standard.

Keywords

electrical protective equipment; electrically insulating plastic guard equipment; plastic guard equipment

To find similar documents by ASTM Volume:

10.03 (Electrical Insulating Liquids and Gases; Electrical Protective Equipment)

To find similar documents by classification:

13.260 (Protection against electric shock. Live working Including tools for working with voltages)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.