ASTM-G17 › Historical Revision Information
Standard Test Method for Penetration Resistance of Pipeline Coatings (Blunt Rod)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This accelerated test method is used to determine the relative resistance of steel pipeline coatings to penetration or deformation by a blunt rod under a specified load. The test method is intended to apply to the testing of all types of nonmetallic pipeline coatings subjected to various temperatures.
1.2 The values stated in SI units to three significant decimals are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
3.1 Since pipeline coatings are subjected to concentrated pressures exerted by the weight of the pipe and the backfill, this test is intended primarily for determining the resistance of the coating to penetration or deformation under controlled conditions.
Keywords
blunt rod; coating; compression; deformation; load; penetration; pipeline; resistance
To find similar documents by ASTM Volume:
06.02 (Paint -- Products and Applications; Protective Coatings; Pipeline Coatings)
To find similar documents by classification:
87.040 (Paints and varnishes Including coating powders, paint coatings and protective paint systems)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-G17-07(2013)
Revision Level
2007 R13 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
July 1, 2013
Document Type
Test Method
Page Count
6 pages
Committee Number
D01.48