ISO-10447 › Historical Revision Information
Resistance welding - Peel and chisel testing of resistance spot and projection welds
Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 10447:2006 specifies the procedure and recommended tooling to be used for testing resistance spot and projection welds by means of peel and chisel tests. ISO 10447:2006 applies to welds made in two or more sheets in the thickness range of 0,5 mm to 3,0 mm.
The aim of these tests is to determine:
- weld size and failure type when the tests are used as destructive tests, and
- verification of welds when the tests are used as non-destructive tests.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 10447:2006
Revision Level
2ND EDITION
Status
Superseded
Publication Date
July 15, 2006
Committee Number
ISO/IIW