ISO-10605 Road vehicles - Test methods for electrical disturbances from electrostatic discharge

ISO-10605 - 2ND EDITION - CURRENT -- See the following: ISO-10605-AM1
Show Complete Document History

Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Included in this current edition are the following subparts:

 2ND EDITION - July 15, 2008
 2ND EDITION CORRIGENDUM 1 - March 1, 2010
 FOR 2ND EDITION AMENDMENT 1 SEE - April 15, 2014

ISO 10605:2008 specifies the electrostatic discharge (ESD) test methods necessary to evaluate electronic modules intended for vehicle use. It applies to discharges in the following cases:

  • ESD in assembly;
  • ESD caused by service staff;
  • ESD caused by occupants.

ESD applied to the device under test (DUT) can directly influence the DUT. ESD applied to neighbouring parts can couple into supply and signal lines of the DUT in the vehicle and/or directly into the DUT.

ISO 10605:2008 describes test procedures for evaluating both electronic modules on the bench and complete vehicles. It also describes a test procedure that classifies the ESD sensitivity of modules for packaging and handling. ISO 10605:2008 applies to all types of road vehicles regardless of the propulsion system (e.g. spark-ignition engine, diesel engine, electric motor).

ISO 10605:2008 is based in part on IEC 61000-4-2 and describes vehicle-specific requirements.

ISO 10605:2008 does not apply to pyrotechnic modules.

ORDER

Price:

$185.00        

To find similar documents by classification:

43.040.10 (Electrical and electronic equipment)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ISO 10605:2008

Revision Level

2ND EDITION

Status

Current

Publication Date

July 15, 2008

Committee Number

ISO/TC 22/SC 3