ISO-10649-2 › Historical Revision Information
Cutter arbors with parallel key and tenon drive - Part 2: Dimensions and designation of tool holders with hollow taper interface with flange contact surface
Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 10649-2:2013 specifies the dimensions of cutter arbors with parallel key and tenon drive with hollow taper interface (HSK) with flange contact surface.
To find similar documents by classification:
25.060.20 (Dividing and tool-workpiece holding devices)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 10649-2:2010
Revision Level
1ST EDITION
Status
Superseded
Publication Date
Aug. 1, 2010
Committee Number
ISO/TC 29/SC 2