ISO-11003-2 › Historical Revision Information
Part 2: Tensile Test Method Using Thick Adherends, Adhesives- Determination of Shear Beha

ISO-11003-2 - 1ST EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:


This part of ISO 11003 specifies a test method for determining the shear behaviour of an adhesive in a single lap joint bonded assembly when subjected to a tensile force.

The test is performed on specimens consisting of thick, rigid adherends, with a short length of overlap, in order to obtain the most uniform distribution of shear stresses possible and to minimize other stress states which initiate failure.

This test method may be used to determine:

  • the shear-stress against shear-strain curve to failure of the adhesive;
  • the shear modulus of the adhesive;
  • other adhesive properties that can be derived from the stress/strain curve such as secant shear modulus and maximum shear stress;
  • the effect of temperature, environment, test speed, etc., on these properties.
ORDER

To find similar documents by classification:

83.180 (Adhesives Including adhesive tapes Adhesive tapes for electrical insulation purposes, see 29.035.20)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ISO 11003-2:1993

Revision Level

1ST EDITION

Status

Superseded

Publication Date

Sept. 15, 1993

Committee Number

ISO/TC 61/SC 11