ISO-1119 › Historical Revision Information
Geometrical product specifications (GPS) - Series of conical tapers and taper angles
Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 1119:2011 provides calculated values for a series of cones or conical tapers, ranging from 120° to less than 1°, or ratios from 1:0,289 to 1:500, intended for general use in technical engineering.
It applies only to plain conical surfaces, and excludes prismatic pieces, taper threads, bevel gears, etc.
To find similar documents by classification:
17.040.01 (Linear and angular measurements in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 1119:1975
Revision Level
1ST EDITION
Status
Superseded
Publication Date
June 1, 1975
Committee Number
ISO/TC 213