ISO-128-40 › Historical Revision Information
Part 40: Basic Conventions for Cuts & Sections, Technical Drawings - General Principles Of
Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This part of ISO 128 specifies the general principles for presenting cuts and sections applicable to all kinds of technical drawings (mechanical, electrical, architectural, civil engineering, etc.) following the orthographic projection methods specified in ISO 5456-2. For areas on cuts and sections, representation is according to ISO 128-50.
Attention has also been given in this part of ISO 128 to the requirements of reproduction, including microcopying in accordance with ISO 6428.
To find similar documents by classification:
01.100.01 (Technical drawings in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 128-40:2001
Revision Level
1ST EDITION
Status
Superseded
Publication Date
June 1, 2001
Committee Number
ISO TC 10/SC 1