ISO-13363 › Historical Revision Information
Corrigendum
Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 13363:2004 specifies requirements for three types and two classes of hose. The hoses are intended for use in marine-engine wet-exhaust systems (where the exhaust gases are mixed with the discharge of cooling water). The standard does not apply to outboard-motor/personal water craft.
The three types are:
- type 1: a softwall hose, made of oil-resistant material, with a synthetic-fabric reinforcement;
- type 2: a hardwall hose, made of oil-resistant material, with a synthetic-fabric reinforcement with an helical wire embedded in it;
- type 3: a hose or tube (flexible connector), made of oil-resistant material, with or without a reinforcement or cover, intended for use in short lengths in locations where the connector is protected from mechanical damage.
The two classes are:
- class A intended for diesel engines;
- class B intended for petrol engines, and for diesel engines with a very high exhaust temperature.
To find similar documents by classification:
83.140.40 (Hoses Hoses for general use, see 23.040.70)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 13363/Cor1:2008
Revision Level
1ST EDITION CORRIGENDUM 1
Status
Superseded
Publication Date
March 1, 2008
Committee Number
ISO/TC 45/SC 1