ISO-15488 › Collets with 8 degree setting angle for tool shanks - Collets, nuts and fitting dimensions
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 15488:2003 specifies the dimensions, materials and manufacturing requirements, and designation of collets (of form A or of form B) for tools with cylindrical shanks and their corresponding holders and nuts. For non-standardized clamping devices, such as clamping devices specified in drawings, these holders can be agreed upon between customer and supplier.
Form A applies to milling and any other application where a hard collet bore is required, provided that the clamping range of h10 be sufficient. Form B applies for general purposes where an extended clamping range is required.
To find similar documents by classification:
25.060.20 (Dividing and tool-workpiece holding devices)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 15488:2003
Revision Level
2ND EDITION
Status
Current
Publication Date
Nov. 15, 2003
Committee Number
ISO/TC 29