ISO-16486-6 › Historical Revision Information
Plastics piping systems for the supply of gaseous fuels - Unplasticized polyamide (PA-U) piping systems with fusion jointing and mechanical jointing - Part 6: Code of practice for design, handling and installation
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 16486-6:2012 specifies a code of practice dealing with unplasticized polyamide (PA-U) piping systems intended to be buried outside buildings and used for the supply of gaseous fuels. It addresses the common basic principles for gas supply systems.
ISO 16486-6:2012 is intended to be applied in association with national standards or codes of practice related to the above-mentioned basic principles.
It is applicable to mains and service lines, the components of which are prepared for jointing by scraping and/or machining, and gives instructions for the design, storage, handling, transportation, laying conditions and fusion quality control of PA-U pipes and fittings up to and including 250 mm outside diameter, as well as subsequent joint testing, backfilling, pipe system testing, commissioning and decommissioning.
It covers butt fusion jointing and electrofusion jointing.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 16486-6:2012
Revision Level
1ST EDITION
Status
Superseded
Publication Date
June 1, 2012
Committee Number
ISO/TC 138/SC 4